How to enable Auto Mode on Socket Mobile Scanner


Latest update: - Ana

Objective

To enable Auto Mode (Presentation Mode) so the scanner will enter Auto Mode when placed in Socket Mobile’s Charging Stand.

 Setup

  • Vend on iPad
  • For Socket Mobile Scanner models CHS 7Qi & 7Xi 

Steps

 

Remove the scanner from your iPad Bluetooth settings:

  1. Open your iPad Settings App
  2. Tap Bluetooth
  3. Tap the 'i' next to the device name
  4. Tap Forget device

Unpair the device and resetting to factory default:

  1. Press and hold on the two buttons on the scanner for 3-4 seconds until you hear three beeps

  2. You can print the Barcode below and scan it to reset the Barcode scanner to factory settings

                 Screen_Shot_2019-02-07_at_10.17.07_PM.png

Enabling Auto Mode:

  1.  Ensure the Socket Mobile Scanner is unpaired 
  2. Once disconnected scan this barcode to enable Auto Mode chs-2d-users-guide.pdf_2019-06-25_12-07-49.png
  3. Once Auto Mode is enabled by scanning the barcode above reconnect the scanner to Vend as  per the setup guide

Additional Information